REVERSING THE DOORS
We recommend that you reverse doors before switching on for the first time.
Tools required: Small and medium size flat and
Spare Parts supplied in the plastic bag: The following parts, which are exclusively for left hand side fitted hinge operation are supplied in a plastic bag with the appliance:
-Upper door top trim hinge covers – there are 2 different parts, one for each side of top trim.
-Upper door middle hinge bushing/door stopper assembly.
(17)(12)
We suggest you keep all the parts supplied in the plastic bag and also parts, which have been removed when reversing doors, in a safe place for possible future,
IMPORTANT: We suggest you ask somebody to help you when moving the appliance around and to hold doors when removing /
Please refer to diagrams supplied. To follow numbers in brackets below, refer to the main diagram.
1. | Switch off the appliance at the socket outlet and pull out the mains plug. |
2. | Remove all loose items and fittings and food, if any, from inside the appliance and door racks. |
3. | Gently prise off plastic hinge cover of upper door top trim using a small |
4. | Gently tilt the appliance back against a strong wall on its rear side sufficiently to allow the lower hinge to be |
| removed. Take care to protect the appliance, your wall and floor coverings. You can utilise the original |
| packaging to do this. Once you tilt the appliance back, check to make sure the appliance is completely |
5. | stable and safe before you carry on. (2) |
Unscrew and remove the lower hinge using a | |
| firmly.(3) |
6. | Remove lower door carefully off the middle hinge and stand door upright in a safe place.(4) |
7. | Open upper door and unscrew and remove the middle hinge while holding the upper door firmly. Use a |
| |
| side.(5) |
8. | Remove upper door carefully off the upper hinge and stand door upright in a safe place.(6) |
9. | Unscrew and remove the upper hinge using a |
10. | Rotate the upper hinge 180 degrees and then unscrew and remove the hinge pin using a pair of pliers and |
11. | opposite side of hinge.(8) |
Reposition plugs and hinge pin bushings on top of doors on the opposite side of both doors. Use small flat- | |
| headed screwdrivers to remove plugs and bushings. Take care not to mark doors.(9) |
12. | Reposition left hand side feet on the opposite side.(10) |
13. | Unscrew and remove the upper door middle hinge pin bushing/door stopper using a |
| screwdriver. Important: This part cannot be used on the opposite side; left hand side middle hinge pin |
| bushing/door stopper part is supplied in the plastic bag.(11) |
7
45°
88
|
|
| 10 |
4 | 4 | 10 |
|
|
|
| |
1 | 2 |
| 11 |
6 |
| 12 | 13 |
5 |
|
|
3
9
14
14. | |
15. | Fit upper door left hand side middle hinge pin bushing/door stopper supplied in the plastic bag using |
16. | |
Reposition three small plastic plugs on the left hand side, which are covering middle hinge holes, on the | |
| opposite side to cover holes left empty.(14) |
17. | Locate and |
18. | Locate the middle hinge pin to middle hinge pin bushing of upper door on the left hand side and |
19. | middle hinge.(16) |
Reposition the two screws fitted to lower hinge holes on the left hand side at the bottom of the cabinet on | |
20. | the opposite side.(17) |
Unscrew and reposition the hinge housing and steel pant on the right hand side at the bottom of the door on the | |
| opposite side. (18) |
21. | Locate and |
22. | Carefully stand the appliance upright and adjust the two front feet if necessary. |
23. | Check that doors open and close easily, they are aligned correctly and that there are no gaps allowing |
| air into the cabinet. If there are gaps between the door seal and the cabinet, adjust the door seal by gently |
24. | pulling away from the door using fingers. |
Check that all the hinge screws are tightened. Avoid over tightening the screws. | |
25. | Put all items, fittings back in the appliance. |
26. | Fit upper door top trim plastic hinge cover. Upper door top trim hinge cover is supplied in the plastic bag.(21) |
27. | Wait for at least 4 hours to allow the system to settle before switching on. |
28. | Once the correct storage temperatures have been reached in the appliance, put back all the food. |
18 | 19 |
17 | |
180° | 22 |
| 19 |
23 | 21 |
20
16
15
7 | 8 |