IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres.
2. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Cookers | 2" | (50 mm) |
From Radiators | 12" (300 mm) | |
From Refrigerators or Larder Fridge | 1" | (25 mm) |
|
|
|
3. Make sure that sufficient room is provided around the appliance to ensure free air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the appliance and the ceiling or the underside of a wall cupboard.
4. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance (See diagram).
5. The appliance should be located on a smooth surface. The two front feet can be adjusted as required.
To ensure that,your appliance is standing | Electronic card |
(covered by plastic cover) | |
upright adjust the two front feet by turning |
|
clockwise or |
|
is in firm contact with the floor. Correct |
|
adjustment of feet avoids excessive |
|
vibration and noise. |
|
6. Refer to "Cleaning and Care" section to |
|
prepare your appliance for use. |
|
7. A special receptacle is supplied to store the |
|
mains plug during transit. |
|
The receptacle is fixed at the back of the |
|
cabinet, on the right hand side of the |
|
compressor. (See diagram) Gently remove |
|
the plug from the receptacle. Never pull |
|
the mains cord, you may damage the |
|
appliance. In the case of transportation, |
|
ensure you locate the plug in the receptacle |
|
provided to avoid transit damage. |
|
STARTING
Final Check
Before you start using the freezer check that:
1.The feet have been adjusted for perfect levelling.
2.The interior is dry and air can circulate freely.
3.Clean the interior as recommended under "CLEANING AND CARE."
4.Insert the plug into the wall socket and switch on the electricity supply.
5.You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the
compressor is running or not which is quite normal.
6.We recommend that you set the thermostat knob at 3 (three) and monitor the temperature to ensure the appliance maintains desired storage temperatures (See
section Temperature Control and Adjustment).
7.Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the
temperature with an accurate thermometer (see; Temperature Control and Adjustment).
Important Notes :
1.If there is a power failure do not open the door. Frozen food should not be affected if the failure lasts for less than 25 hours. If the failure is longer, then the food should be checked and either eaten immediately or cooked and then
2.If you find the freezer door difficult to open just after you have closed it, don't worry. This is due to the pressure difference which will equalise and allow the door to open normally after a few moments.
3.You will hear a suction sound just after closing the door. This is quite normal.
5 | 6 |
