Beko TZDA 629 F manual Electronic card

IMPORTANT
INSTALLATION INSTRUCTIONS
1.	The space in the room where the appliance is installed must not be smaller
		than 10 cubic metres.
2.	If possible avoid placing the appliance near cookers, radiators or in direct
		sunlight as this will cause the compressor to run for long periods. If installed
		next to a source of heat or refrigerator, maintain the following minimum side
		clearances:
		From Cookers	2"	(50 mm)
		From Radiators	12" (300 mm)
		From Refrigerators or Larder Fridge	1"	(25 mm)
3.
	Make sure that sufficient room is provided around the appliance to ensure free
		air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the
	fridge and the ceiling or the underside of a wall cupboard.
4.	Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn
	to the condenser at the back of the appliance (See diagram).
5.	The appliance should be located on a smooth surface.					Electronic card
					(covered by plastic cover)
	The two front feet can be adjusted as required.
	To ensure that,your appliance is standing
	upright adjust the two front feet by turning
	clockwise or anti-clockwise, until the product
	is in firm contact with the floor. Correct
	adjustment of feet avoids excessive
6.		vibration and noise.
	Refer to "Cleaning and Care" section to
	prepare your appliance for use.

7.A special receptacle is supplied to store the mains plug during transit.

The receptacle is fixed at the back of the cabinet, on the right hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.

5

INDICATOR LIGHTS

There are three coloured indicator lights located on the front of the appliance which shows the operating mode of the freezer.

Indicator lights slightly flicker. This is by design and not a fault, don’t worry. This low energy consumption design is developed to achieve the lowest possible electiricty use.

Green Indicator (1)

Illuminates when the appliance is connected to the mains and will glow as long as electricity is available. The green indicator does not give any indication of the temperature inside the freezer.

Amber Indicator (2)

This indicator will glow when the fast freeze button (4) is on and will continue to glow for 34 hours until the fast freeze button is turned off. It will automatically turn off after 34 hours otherwise, the compressor will run continuously while fast freeze button is on. Fast freeze operation is for freezing fresh food (See Freezing Fresh Food, page 9).

Red Indicator (3)

Red indicator light has a built-in delay. Once switching on, it will not come on for 24 hours.

This indicator will glow when the internal temperature rises above -5°C and it will automatically de-activate when the internal temperature falls below -9°C

Thermostat Knob (5)

Thermostat knob is located on the indicator light set.

Temperature Display (6)

Display shows actual internal temperature. When you switch on fast frezee, it will display - 27 °C for 5 seconds. When you rotate the knob, it displays the new setting for 5 seconds and then reverts back to actual temperature.

IMPORTANT :

When you press the fast freeze button (4), there may be a short delay before the compressor starts to operate. This is normal and not a compressor fault, don’t worry.

-E0 flashes on display (6) if there is a freezer sensor failure.

-E1 flashes on display (6) if there is a defrost sensor failure.

-E4 blinks on display if there is a heater failure.

4	5	6	2	1	3
			6