Belkin 4200 user manual Siemens Speedstream, Hardware Connections, It’s as easy as, Step A

Siemens Speedstream 4200

Step A

If you have not already done so please connect the SpeedStream 4200 modem directly to your computer with a network cable (Ethernet), ensure your Internet connection is working. If you are having any problems setting up the Optus-provided SpeedStream 4200 modem, you will need

to contact the Optus ADSL support line.

Step B

After you have confirmed that your Internet connection is set up and you can browse the web, you will need to follow the remaining steps in this document. Log into the modem by opening up Internet Explorer on your

PC and type http://10.1.1.1 in the address bar and press enter.

Step C

Click on “Setup” in the menu on the left, then click “Mode”.

Step D

Under “Select the operation mode” select NAPT and click Apply.

Step E

Click on OK to save settings then click the Reboot button to restart the modem.

Step F

Wait approximately 2 minutes, then close your web browser. This is usually done by clicking the cross on the top right hand corner of the screen.

Step G

Restart your web browser and ensure you can surf the internet, then close your browser and continue with this guide.

Page 4 of 4

©2006 Belkin Corporation. All rights reserved. All trade names are registered trademarks of respective manufacturers listed.

P75168au

F5D8231au4

Open and remove contents of box. You will find the following items:

Installation Software CD

N1 Wireless Router

Power Supply

Ethernet Cable

User Manual on CD

It’s as easy as 1-2-3

1Hardware Connections: Use the instructions in this Guide to connect your router, computer, and modem.

2Setup Assistant: Insert the CD into your computer and follow the on-screen instructions.

3Finish:

You’re ready to surf the internet.

N1 Wireless Router Quick Installation Guide

Thankyou for purchasing a Belkin router, you will need to run through the following steps once to set up your router.

Note: If you are using an Optus provided ADSL service and you are using a D-Link or Siemens modem provided to you by Optus (not purchased by you in a retail store), please refer to pages 3 and 4 of this installation guide.

If you are not using Optus ADSL, continue on this page.

1 Hardware Connections

Step A

Unplug your modem’s power cord.

Put the Router next to the modem.

Raise the Router’s antennas.

��������

������

�����

Step B

Locate the networking cable that connects your modem and computer.

Unplug that cable from your modem, and plug it into any gray port on the back of the Router.

Step C

Find your new networking cable (it came in the box with your Router) and connect it to the yellow port on the back of

the Router.

Connect the other end to your modem, in the port that’s now free.