INSTALLATION
Pre-Configuration
Where to Place the KVM Switch:
The OmniView E Series KVM Switch is designed to sit on the desktop. Where you place the KVM Switch will be based on the location of your CPUs and the length of your cables.
Cable Distance Requirements:
For PS/2 computers: VGA signals are best retained when transmitted up to 25 feet (7.5m). Beyond 25 feet (7.5m), probability of video degradation increases with an increase in distance. For this reason, your PS/2 computer should be placed within 25 feet (7.5m) of the KVM Switch.
Note: If your computer needs to be more than 25 feet (7.5m) from the KVM switch, you can use the Belkin CAT5 Extender to extend your PS/2 keyboard, PS/2 mouse, and monitor up to 500 feet (152.4m) away using standard CAT5 UTP cable.
INSTALLATION
Step-by-Step Installation Guide
This section provides complete instructions for the hardware setup of a single E Series KVM Switch. (F1DB102P or F1DB104P)
Important Note:
Before attempting to connect anything to the E Series KVM Switch or to any computer, make sure that everything is powered off. Plugging and unplugging cables while computers are powered on can cause irreversible damage to your computers and/or KVM switch. Belkin Components will not be responsible for damage caused by these actions.
Keyboard, Video, and Mouse Connections for E Series KVM F1DB102P, F1DB104P
Cautions and Warnings:
Avoid having cables near fluorescent lights, air conditioning equipment, or machines that create electrical noise (e.g., vacuum cleaners).
π
CONNECT THE CONSOLE:
1.
Connect the monitor to the E Series KVM Switch. Using the cable that is included with your monitor, connect it to the HDDB15 female port on the top of the E Series KVM Switch with the monitor symbol on the console.
|
8
2.
Connect a PS/2 keyboard to the PURPLE port on the CONSOLE.
3.
Connect a
9 |
