Belkin F1DN104D, F1DN102D user manual OmniView Secure KVM Switch, Toe

OmniView® Secure KVM Switch

Belkin OmniView® Secure DVI Dual-Link KVM Switch User Manual Common Criteria Supplement Models: F1DN102D F1DN104D

This section supplements the Belkin Quick Installation Guide in accordance with AGD_PRE.1 Common Criteria Assurance Measure requirements.

This User Guidance and Common Criteria EAL 4 validation apply to the TOE Common Criteria Evaluated version of OmniView® Secure KVM Models listed below:

•F1DN102D

•F1DN104D

Before you begin: The users of the Belkin OmniView® Secure DVI Dual-Link KVM Switch must review all associated documentation and guidance prior to proceeding with installation and use of the KVM Switch. All documentation and guidance can be found in the following document(s):

•Belkin OmniView® Secure DVI Dual-Link KVM Switch User Manual F1DN102D, F1DN104D (document number PM00507)

•Belkin OmniView® Secure DVI Dual-Link KVM Quick Installation Guide F1DN102D, F1DN104D (document number PM00506)

1.1Receipt and preparation of TOE and Environment prior to installation Receipt

•Assure that tamper seals are intact on the KVM switch. There should be one tamper-evident tape on each side of the Switch enclosure (total of two tapes). If both tapes are visible and do not appear to be disrupted, the

Switch has not been opened or compromised since time of production. If for any reason one of the tapes is missing or appears disrupted, the user should call Belkin Technical Support at (800) 282-2355.

Environment preparation

•The Belkin OmniView KVM secure must be located in a physically secure location providing physical protection and limited (authorized user) access controls.

1.2Verification of Common Criteria components

The following are authorized devices for the Common Criteria Evaluated configuration. Assure that installation processes resulting in the following hardware/firmware configuration:

TOE	Belkin Secure DVI Dual-Link KVM Switch 2-Port PN # F1DN102D v.111111 (or)
	Belkin Secure DVI Dual-Link KVM Switch 4-Port PN # F1DN104D v.111111
	including: Firmware software component version 1.0.1
Environment	USB Mouse (Peripheral Group Member)
Environment	USB Keyboard (Peripheral Group Member)
Environment	Monitor – Dual-Link DVI connector (Peripheral Group Member)
Environment	Host Computers Qty. 2 or 4 based on KVM used (IT Environment Computer Resources)
Environment	Belkin DVI/USB KVM Cable (one per KVM):
	F1D9201-06	– 6 ft. (1.8m)
	F1D9201-10	– 10 ft. (3m)
	F1D9201-15	– 15 ft. (4.6m)

Belkin OmniView® Secure DVI KVM Switch User Manual Common Criteria Supplement