Manuals / Belkin / Computer Equipment / Network Card

Belkin F5D7000 user manual Diagnostics Page, d WEP, e Ad-Hoc Networks Only, f Advanced, g Freeze

Models: F5D7000

1 19

Download 19 pages 13.18 Kb

Page 15

(d) WEP

USING THE BELKIN WIRELESS LAN UTILITY

(d) WEP

Will display “Off” when encryption is disabled, “64-bit” when 64-bit encryption is enabled, and “128-bit” when 128-bit encryption is enabled.

(e) Ad-Hoc Networks Only

Check this box to display available ad-hoc networks only.

(f) Advanced

Displays additional information about the selected network.

(g) Freeze

Takes a “snapshot” of the signal strength at the time of the site survey. Click again to unfreeze.

USING THE BELKIN WIRELESS LAN UTILITY

Diagnostics Page

This Page allows you to perform several diagnostic tests that are available for your Belkin Wireless Network adapter.

Control Registers

This test verifies the read and write capabilities of the network controller registers by writing various values to the registers and verifying the result. The device driver uses these registers to perform network functions such as sending and receive information. If the test fails, the network adapter may not work properly.

SPROM Format Version

This test verifies the content of the SPROM by reading a portion of the SPROM and computing the checksum. The test fails if the computed checksum is different than the checksum stored in the SPROM.

26

27

Image 15

Belkin F5D7000 user manual Diagnostics Page, d WEP, e Ad-Hoc Networks Only, f Advanced, g Freeze, Control Registers

Contents

P74216 54g Wireless Desktop Network CardShare your broadband Internet connection and files F5D7000INTRODUCTION TABLE OF CONTENTSApplications and Advantages FeaturesDifficult-to-wire environments OVERVIEWc Card Connector Product SpecificationsPackage Contents a Power LEDINSTALLING AND SETTING UP THE CARD Software and Driver InstallationINSTALLING AND SETTING UP THE CARD INSTALLING AND SETTING UP THE CARD INSTALLING AND SETTING UP THE CARD8. Remove the CD from the CD-ROM drive and shut down your computer INSTALLING AND SETTING UP THE CARD Installing the Card into your PC for Windows 98, Me, 2000, and XPFinishing the Installation INSTALLING AND SETTING UP THE CARDINSTALLING AND SETTING UP THE CARD INSTALLING AND SETTING UP THE CARDGreen Icon Connected to a wireless network, good connection INSTALLING AND SETTING UP THE CARD Connecting to your Wireless NetworkUninstalling the Software and Drivers USING THE BELKIN WIRELESS LAN CONFIGURATION UTILITYUSING THE BELKIN WIRELESS LAN CONFIGURATION UTILITY USING THE BELKIN WIRELESS LAN CONFIGURATION UTILITYClick “Cancel” to exit c Preferred Networks USING THE BELKIN WIRELESS LAN UTILITYThe Wireless Networks Tab a Enable RadioUSING THE BELKIN WIRELESS LAN UTILITY Encryptionl Advanced USING THE BELKIN WIRELESS LAN UTILITYb MAC Address i Signal StrengthThe Link Status Tab a SSIDb Channel Number c Signal StrengthThe Site Survey Tab The Statistics Tabf Advanced Diagnostics Paged WEP e Ad-Hoc Networks OnlyCannot Connect to the Network TROUBLESHOOTINGProblem or Symptom Possible SolutionCont Technical SupportTROUBLESHOOTING TROUBLESHOOTINGModifications INFORMATIONFCC Statement DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITYINFORMATION Belkin Corporation Limited Lifetime Product Warranty