Belkin F5U271EA user manual Hardware Installation

1

___

2

___

3

___

4

___

Installation Procedure for Windows

c)Windows 98 SE does not support mass-storage devices; therefore, the Belkin driver must always be installed.

Hardware Installation

Important Note: Please do not connect any USB devices to the Hub’s ports until the installation process has been completed.

1.Plug the AC adapter into a wall outlet or surge suppressor. Plug the DC connector into the DC power jack found on the rear of the Reader.

Note: The hub may be used without the power supply with most USB devices.

2.Plug the flat end (USB-A connector) of the provided USB device cable into the downstream port of your computer, or downstream port of another hub. Plug the small end (USB-B mini-B connector) into the USB-B mini-B connector on the back of the Reader.

Important Note: The Reader must be connected to a USB 2.0-compliant host in order to function in Hi-Speed mode (480Mbps data rate). If the Hub is connected to a USB 1.1-compliant host, it will operate only in low-speed or full-speed mode (1.5Mbps/12Mbps).

10EN