Belkin F6C110-RKM-2U Faqs, Maintenance, Battery Replacement, Symptom Possible Cause What To Do

FAQS

Symptom	Possible Cause	What To Do
UPS will not turn on	On/Off/Test button not pushed	Press the On button
		momentarily (one beep to
		start UPS)
UPS operates in battery mode	Input AC circuit breaker is	Reset circuit breaker by
only, even though there is	tripped	pressing the plunger back in.
normal AC present		If the AC circuit breaker trips
		after UPS starts up, reduce the
		load on the UPS.
The UPS emits a sustained tone	UPS has detected an internal	Call for service
	fault
The Site Wiring Fault LED is	Incorrect service wiring	Have a qualified electrician
illuminated		correct the service wiring
The Battery On LED is	The UPS is being controlled via	Disconnect the computer cable
illuminated, but there	its computer port.	from the UPS and press the On
is no output		button momentarily. If UPS
		works normally, software has
		control of the UPS.
UPS does not provide expected	The batteries may be weak or	Charge the batteries for 8 hours
backup time with internal	at the end of useful service life.	and retest. If the backup time
batteries or with a battery pack	The battery pack’s circuit	is still less than expected, the
	breaker may be tripped.	batteries may need to be
		replaced, even though the
		Weak/Bad Battery LED is not
		illuminated. Reset the battery
		pack’s circuit breaker.
Replace Battery LED is	Weak or bad batteries/bad	Check battery connection/
illuminated	battery connection	replace batteries. Follow battery
		replacement procedures in
		section 6.
UPS occasionally emits a beep	Normal operation	The UPS is performing its
		intended function.
Overload LED is illuminated and	The load has exceeded the UPS’	Check the specifications (see
a constant alarm sounds	capacity	section 8). Remove part of the
		load.
The Battery On LED is blinking	The UPS is in either the Buck	The UPS is performing its
and the audible alarm is silent	mode or the Boost mode	intended function.

MAINTENANCE

Battery Replacement

The OmniGuard Rackmount series has easy-to-replace hot-swappable batteries. Please read the following warning statements before attempting to service the battery(s). NOTE: If there is a power interruption while replacing the hot- swappable batteries, with the UPS on, the load will not be backed up.

WARNING: This Uninterruptible Power Source contains potentially hazardous voltages. Do not attempt to disassemble the unit beyond battery replacement procedures below. Except for the battery, this UPS contains no user-serviceable parts. Repairs should be performed by service personnel only

CAUTION: Do not open or mutilate batteries. Released electrolyte is harmful to the skin and eyes and may be toxic.

CAUTION: Although battery system voltages are only 24VDC and 48VDC, the battery system can still present a risk of electrical shock. The current capability of a battery is sufficient to burn wire or tools very rapidly, producing molten metal. Observe these precautions when replacing the batteries:

1.Remove watches, rings, or other metal objects.

2.Use hand tools with insulated handles.

3.Do not lay tools or other metal parts on top of batteries.

CAUTION: Replace batteries with the same number and type as originally installed in the UPS. These batteries have pressure- operated vents.

Series Model #	Battery Model #
F6C110-RKM-2U	12V	7.2Ah
F6C150-RKM-2U	12V	4.5Ah
F6C230-RKM-2U	12V	9Ah
F6C320-RKM-3U	12V	12Ah

24 25