Belkin F6C325, F6C525, F6C625, F6C425 user manual Troubleshooting, Storage, Specifications

Troubleshooting

PROBLEM	POSSIBLE CAUSE	SOLUTION
UPS not on	On/off/test/ button not	Press the on/off/test button
LED not lit	pushed or pushed less	more than 1 second
	than 1 second
	Battery voltage less than	Recharge the UPS at least
	10V	4 hours
	Load less than 20W	Normal condition
	at battery mode
UPS always at	Power cord loose	Replug the power cord
battery mode
	AC fuse is burned out	Replace the AC fuse
	Line voltage too high, too	Normal condition
	low or black out
Back up time too short	Battery not fully charged	Recharge the UPS at
		least 4 hours
The UPS continuously	Overload	Remove the
beeps		noncritical loads
RED LED lit	Battery failure	Replace battery

Storage

11.0Storage Conditions

Store the UPS covered and upright in a cool, dry location, with its battery fully charged. Before storing, charge the UPS for at least 4 hours. Disconnect any cables connected to the computer interface port to avoid unnecessary drainage of the battery.

11.1Extended Storage

During extended storage in environments where the ambient temperature is -15˚C to +30˚C (+5˚F to +86˚F), charge the UPS battery every 6 months.

During extended storage in environments where the ambient temperature is +30˚C to +45˚C (+86˚F to +113˚F), charge the UPS battery every 3 months.

Specifications

MODEL		F6C325	F6C425	F6C525	F6C625
INPUT	Capacity	325VA	425VA	525VA	625VA
	Voltage	100V, 110V, 120V, ±25%
	Frequency	50Hz or 60Hz ±5% (auto sensing)
OUTPUT	Voltage	Simulated sine wave at Line Input ±5%
	(on battery)
	Frequency	50Hz or 60Hz ±0.5%
	(on battery)
	Voltage	AVR automatically increases output voltage
	Regulation	15% above input voltage if -9% to -25% of
	AVR	nominal. AVR decreases output voltage
		13% below input voltage if +9% to
		25% of nominal
	Transfer Time	2-4 milliseconds, including detection time
PROTECTION AND	Spike Protection	320 Joules, 2ms
FILTERING	EMI/RFI filter	10dB at 15MHz,
		50dB at 30MHz
	Overload	UPS automatic shutdown if overload
	Protection	exceeds 110% of nominal at 60 second
		and 130% at 3 seconds
	Unit Input	Fuse for overload and short circuit protection
	10Base-T	Network (UTP, RJ45) compatible jacks
	Cable Port	(F6C425, F6C525, F6C625)
	Short Circuit	UPS output cut off immediately or input
		fuse protection
BATTERY	Type	Sealed, maintenance-free lead acid
	Typical	4 hours (to 90% of full capacity)
	Recharge Time
	Protection	Automatic self-test and discharge protection,
		replace battery indicator
	Back up Time	Depending on computer load...
		5-17 min.	5-24 min.	5-32 min.	5-41 min.
PHYSICAL	Net Weight	4.7(10.4)	5.8(12.8)	6.2(13.7)	6.5(14.3)
	Kg(lbs)
	Shipping Weight	5.0(11.0)	6.1(13.4)	6.5(14.3)	6.9(15.2)
	Kg(lbs)
	Dimension(mm)	97x260x135		97x320x135
	WxDxH
	Input Inlet	IEC 320 power inlet
ALARM	Battery	Slow beeping sound (about 0.47Hz)
	Back-Up
	Battery Low	Rapid beeping sound (about 1.824Hz)
	Overload	Continuous beeping sound
INTERFACE	RS232	Bi-directional communication port
	Interface	(F6C425, F6C525, F6C625)
CONFORMANCE	Safety	cUL, TUV, CE, meet FCC
	Surge	Meet IEEE 587 standard
ENVIRONMENT	Ambient operation	6,000 meters max. elevation, 0-95% humidity
		non-condensing, 0-48˚C
	Audible noise	<40dBA (1 meter from surface)
	Storage condition	15000 meters max. elevation

14 15