Belkin P72114 warranty Usage, Scan Mode

Connecting one OmniView into another is just like connecting a computer into an OmniView. The cable kit used is the A3X982, plus an F2N209-xx-T if a serial mouse is present. Simply connect the cascaded OmniView’s console port to one of its “parent” OmniView’s free ports, as below:

Usage:

Selecting which computer to operate can be done in two different ways - either by pressing the front-panel pushbuttons, or by entering the hot-key sequence.

•Pressing the pushbuttons in front directly switches to the selected port on the OmniView, as shown by the solid green light on either Port #1 or #2.

To select a computer on cascaded OmniViews, press the button to select the port where the cascaded OmniView is connected. Then, select the port on the cascaded OmniView where the desired computer is connected.

•Entering the hot-key sequence allows direct port access from the keyboard, even through cascaded OmniViews. The procedure is very simple, and easy to remember:

1.Press <ALT>+<CTRL>+<SHIFT> all at the same time, then release.

2.Press the port number of the computer you wish to control. If you have cascaded OmniViews, you will have to press two (or three) numbers, x y z, where x is the port on the top level OmniView, y is the port on the second level OmniView, and z is the port on the third level OmniView. Press the correct key (or keys in succession), then release.

3.Press <ENTER>, then release.

You should hear a beep to confirm the OmniView has switched to the desired port. For example, pressing <ALT>+<CTRL>+<SHIFT> 1 2 3 <ENTER> selects Port 1 on the top level OmniView, Port 2 on the second level OmniView, and Port 3 on the third level OmniView. The OmniView filters out the hot-key sequences, preventing unwanted characters from appearing in the computer’s applications.

Scan Mode

The OmniView can be set for automatic scan mode. In scan mode, the OmniView switches from one computer to the next in regular time intervals set by the DIP switches. When the OmniView is in scan mode, there is no keyboard control passed to the displayed computers. This is necessary because switching is handled by the OmniView, not the operator.

Note: Scan mode will continue indefinitely, until the <SPACE> bar is pressed and scan mode is terminated. Also, the OmniView will only scan to ports that have computers enabled on it.