Belkin P75470ea manual Installation

Installation

Important Note: Please do not connect any USB devices to the Hub until instructed to do so in step 4 of this installation procedure.

1.Plug the AC adapter into a wall outlet or surge protector. Plug the DC connector into the DC power jack found on the rear of the Hub.

2.Plug the flat end of the provided USB device cable into the downstream port of your computer, or downstream port of another hub, and then plug the mini-USB connector of the device cable into the upstream port on the rear of the Hub.

Important Note: The Hub must be connected to a USB 2.0-compliant host in order to function in high-speed mode (480Mbps data rate). If the Hub is connected to a USB 1.1-compliant host, it will operate only in low-speed or full-speed mode (1.5Mbps/12Mbps).

1

2

3

4