BENDIX BW1641 manual Bendix ASA-5Slack Adjuster Template

L	6˝
I
N
K	5.5˝
P	}5˝
I
N

6˝	Y
	O
	K
5.5˝	E
	P
	I
5˝ {N

Bendix® ASA-5®Slack

Adjuster Template

1.Block the wheels, mechanically cage the parking brakes and drain all air pressure from the system.

2.Before installing the ASA-5®slack adjuster, read the installation instructions packaged with the service replacement ASA-5®slack adjuster, or the service data sheet SD-05-1269.

3.Remove the existing slack adjuster and yoke.

4.Install the ASA-5®slack adjuster on the brake camshaft.

5.Center the hole “A” on the brake camshaft.

6.Center the ASA-5®slack adjuster yoke pin in the template hole.

7.The full diameter of the ASA-5®slack adjuster link pin must be with- in the appropriate slot in the template (6˝ yoke pin to 6˝ link pin, etc.). If not aligned, adjust the yoke adapter on the actuator rod.

BW1641 © 2009 Bendix Commercial Vehicle Systems LLC 12/2009

Printed in U.S.A. All rights reserved.

HOLE

A

This template is not needed for the ASA-5®slack adjuster installation. Please refer to the installation instructions included with your product. This template can be used for assistance, if needed.

Please print this template at 100% on cardstock for assistance with the installation of your ASA-5®slack adjuster.