Operation
Starting up the projector
1.Plug the power cord into the projector and into a power outlet. Turn on the power outlet switch (where fitted). Check that the POWER indicator light on the projector lights orange after power has been applied.
2.Open the lens cover. If it is closed, it could become deformed due to the heat produced by the projection lamp.
3.Press 
Power on the projector or remote control to start the projector. As soon as the lamp lights up, a "Power On Tone" will be heard. The POWER indicator light flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before energizing the lamp.
To turn of the ring tone, see "Turning off the
Power on/off ring tone" on page 39 for details.
4.If the projector is activated for the first time, select your OSD language following the
5.If you are prompted for a password, press the arrow keys to enter a
6.Switch all of the connected equipment on.
7.The projector will start to search for input signals. The current input signal being scanned displays in the upper left corner of the screen. If the
projector doesn't detect a valid signal, the message “No Signal” will continue displaying until an input signal is found.
You can also press SOURCE on the projector or remote control to select your desired input signal. See "Switching input signal" on page 29 for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message “Out of Range” displayed on a blank screen. Please change to an input
