Step 1. Turn the power off and disconnect the projector from the wall socket. Step 2. Turn the projector over. Then loosen the
screws and remove the lamp cover. If the lamp is hot, avoid burns by waiting for 45 minutes until the lamp has cooled.
Step 3. Move the latch to another end as shown in the picture.
Step 4. Loosen the screw that holds the lamp to the projector. If the screw is not loosened completely, they could injure your fingers. It is strongly recommended that you use a
Step 5. Lift the handle so that it stands up. Use the handle to slowly pull the lamp out of the projector.
Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector.
Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials.
Do not insert your hands into the projector after the lamp is removed. If you touch the optical
components inside, it could cause color unevenness and distortion of the projected images.
Step 6. Insert a new lamp. Make sure the handle is fully locked, move the latch back, and tighten the screw firmly.
Loose screw may cause a bad connection, which could result in malfunction.
Do not over tighten the screw.
Step 7.
is replaced, reset the total lamp operation time. Do not reset if the lamp is not replaced as this could cause damage.
