Berkel PM30, PM40 important safety instructions R3$,53$57653$,5659

•Turn the timer to “hold” position, shift to the desired speed and then move the start toggle button.

•Transmission adjustment may be necessary. Contact your nearest Designated Berkel Service Location.

Overload circuit breaker tripped

•Mixer is overloaded causing the circuit breaker to trip. See the Product Capacity Chart on page 13.

Mixer slips out of gear under load

•Make sure the shift lever is adequately engaged.

•If mixer shift lever is adequately engaged and slipping still exists, then contact your nearest Designated Berkel Service Location

Product not being properly mixed at the bottom of the bowl

•Inadequate water to product ratio (AR)

•Excessive clearance at the bottom of the bowl and attachment. Contact your nearest Designated Berkel Service Location.

R(3$,53$5765(3$,56(59,&(

Please contact your nearest Designated Berkel Service Location for any repair parts and/or repair service required on your Berkel slicer. A list of DBSL’s can be found on the website at www.berkel.com. Pull down the service tab and then click on your start for the nearest DBSL. Additional information may be obtained from:

Technical Service Support Center

Berkel Company

4406 Technology Drive

South Bend, IN 46628-9700

(574)232-8222

(800)348-0251

PM30 & PM40 OWNER/OPERATOR MANUAL • 11