4. CLEANING THE INSIDE OF THE APPLIANCE
The electrical parts or parts of the motor assembly inside the range hood must not be cleaned using liquids or solvents.
Do not use abrasive products. All the above operations must be performed after having disconnected the appliance from the mains power supply.
M 
SAFETY WARNINGS
The electrical system features an earth connection in compliance with interna- tional safety standards; furthermore, it is compliant with the European standard for electromagnetic compatibility.
Do not connect the appliance to flues (from boilers, fireplaces, etc.). Make sure the mains voltage corresponds to the values on the rating plate located inside the range hood. The minimum safety distance between the cooktop and the range hood must be at least 65 cm (25,6”).
Never cook on “open” flames under the range hood.
Check
-Ensure there is adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels.
-Do not flambe under the rangehood.
-The exhaust air must not be discharged into a flue which is used for exhaust- ing fumes from appliances burning gas or other fuels.
-Ensure that all regulations concerning the discharge of exhaust air have been fulfilled before you use the appliance.
Before performing any cleaning or maintenance operations, disconnect the ap- pliance by unplugging it or using the main switch. The manufacturer disclaims all liability for any damage that may be directly or indirectly caused to people, things and animals due to the failure to follow all the instructions provided in this booklet and above all the warnings relating to the installation, operation and maintenance of the appliance.
N |
WARRANTY
The new equipment is covered by warranty. The warranty conditions are pro- vided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or transcription errors. The manufacturer reserves the right to modify its products as it considers necessary or in the interests of the user, without compromising their essential safety and operating characteristics.
O |
ASSEMBLY INSTRUCTIONS (fig. O)
Step 1: - Remove the metal filters
Step 2: - Screw off the 6 screws (A) and the 2 knurled pins (B), then remove the botton part.
Step 3: - Insert the hood into the forniture hole fix the hood using 10 screws for wood (C).
Step 4: - Before making the electrical connections disconnect the power sup- ply.
- Repeat step 1,2 to mount the botton part and the metal filters.
11
