MOUNT HOOD TO SUPPORT FRAME
1.Install the hood to support frame by (6) mounting screws (3.9x9.5mm), minding that the controls are on the proper side.
2.Make electrical connections (refer to the section “WIRING”).
3.Remove the two temporary fixing screws of the lower flue and set it in place on the hood.
WIRING
Note: This range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes.
1.Remove the wiring box cover. Remove a knockout from the wiring box.
2.Feed 6" of power cable through the knock- out opening and secure cable to the wiring box with an appropriate connector.
3.Make electrical connections. Connect white to white, black to black and green to green.
4.Replace wiring box cover and screws. Make sure that wires are not pinched between cover and box.
NON-DUCTED RECIRCULATION FILTER INSTALLATION
1.Purchase a charcoal filter (FILTER SQUARE - cod.B03300488) from your dealer.
2.Install the charcoal filter by pressing the 2 tabs on the filter down into the special housing and rotating upward.
MOUNTING
SCREWS
(3.9X9.5MM)
WIRING BOX
COVER
CHARCOAL
FILTER
- 10 -
