7.To avoid popping, try holding the microphone at a slight angle below your mouth.
8.To avoid covering the integrated antenna by your hand, do not hold the microphone at the microphone head as this could reduce the transmission strength. Furthermore, feedback can occur.
2.3Maintenance
Protect the microphone from humidity, knocks and shock. Avoid dropping the micro- phone at all times.
If your microphone sounds dull, clean the integrated foam pop shield. To do this, follow the instructions below.
•SDM 169: Unscrew the microphone upper basket counter clockwise.
SDM 159, SEM 181: Unscrew the whole microphone basket clockwise.
•Pull out the foam pop shield and clean it under clear running water. If necessary, use a mild
•Place the dry pop shield inside the microphone basket and replace the microphone basket by screwing it on clockwise or counter clockwise.
3.TS 100 Beltpack Transmitter
3.1Controls and Indicators
On Off
Mute Peak Vol
On Off
Batt Power
(1) | (2) | (3) | (4) | (5) | (6) |
Opus
(1) Mute switch
TS 100 V
VHF Transmitter
(2)red Peak LED (audio)
(3)Gain control (audio)
(7)
(4)Connection for microphones / instruments, 3.5 mm stereo jack (female),
(5)green Power On battery condition LED
(8)
(6)On / Off switch
(7)Antenna
(8)Battery compartment
3.2Setting up
1.Open the battery compartment (8) by pulling the cover downwards. Insert a 9 V alkaline battery or rechargeable battery observing the polarity +/- marks.
20
