802.11g ADSL2+ VPN Firewall Router
Chapter 4: Configuration
Note: You should setup each VLAN group with caution. Each Bridge Interface is arranged in this order.
Bridge Interface VLAN Port (Always starts with)
Ethernet P1 / P2 / P3 / P4
Ethernet1 P2 / P3 / P4
Ethernet2 P3 / P4
Ethernet3 P4
Step 2: Create WAN Interface
Go to Configuration WAN ISP
wanlink is the factory default WAN interface which in service for data/internet access. If your ISP uses
this access protocol, click Edit to input other parameters if needed. If your ISP does not use PPPoE,
you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to change
the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is support;
therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC 1483
Bridged and click Next to continue the setup.
136