message ‘NO HOMEPLUG ADAPTERS DETECTED’.
The lower panel displays all the HomePlug remote devices, detected on the current network. The total number of remote devices connected on the same network can be found on top of the Remote device panel.
The Network type (Public or Private) is also displayed based on the network status of the local device. The scan status option is displayed on the top right corner above the Remote devices panel showing whether the Autoscan function is turned ON or OFF.
The following information is displayed for all devices that appear in the lower panel: Device Name:
Show the default device name. User can change the name by either clicking on the rename button or by clicking on the name and editing
Password (*required when creating a private network)
This column is left blank by default. The password will be displayed only after it has been created. For detail information on password setup, please refer to section on
Password Setup Procedure.
Rate (Mbps):
Display the data transmission rate of each device.
MAC Address:
Show the Remote device MAC address.
Quality:
Display the overall quality of the data transmission rate. When the transmission rate is good, the number of line appear will increase.
