BC2403 Series Brush Cutter Owner’s Manual
OPERATOR CONTROLS
The operator’s station is at the rear of the machine between the handlebars. The operator should STAND in a position to allow both handlebars to be grasped firmly and which allows sufficient leverage to steer the machine. Operator’s controls are shown below.
1 
2 
3
| Operator Control Locations | ||
1 | Blade Clutch Lever 5 | ON/OFF Switch | |
2 | Gear Shift Lever | 6 | Drive Clutch Lever |
3 | Choke | 7 | Pull Starter |
4 | Throttle |
|
|
STARTING
CHECK engine oil level before operating machine.
4
5
6
7
1.Place equipment on a level, firm surface that is free of rocks or other debris.
2.Place throttle in START position.
Throttle
Part No 500360 | 11 | F050208A |
