Part No 440179 Form No F041108A
9
FORCE BLOWER 18 Owner’s Manual
ASSEMBLY
Figure A Figure B
1.Follow the steps in figures A and B, then securely tighten all hardware shown.
2.Connect spark plug wire.
The hardware for attaching the upper handle to the lower
is in the parts bag. Install upper handle (item 30), to
preassembled lower handle (item 28) by sliding the upper
over and down the outside of the lower handle. Using bolt
(item #36), washers (item #10) & lock nut (item #11) to
install upper handle to lower handle. Finish installing the
other side of the upper handle assembly using screw and
lock nut provided.
The throttle control and Aim-and-Shoot
TM
will be attached
to the throttle arm on the engine and wrapped around the
engine for shipping. Unwrap and secure throttle control
(item #31) to upper handle with screws (item #17).
Screws will already be mounted in handle, simply remove
and use to mount the throttle control securing the cable
with two Ty-wraps.
Two ½” open ended wrenches
One 3/8 open ended wrench