Billy Goat F800 Periodic Maintenance, Impeller Removal, Tire Air Pressure, Storage

FORCE BLOWER Owner’s Manual

MAINTENANCE

PERIODIC MAINTENANCE

Periodic maintenance should be performed at the following intervals:

Maintenance Operation	Every	Daily or Every	Every 25	Every 50	Every
	Use	5 Hours	Hours	Hours	100-150
					Hours
Inspect for worn or damaged parts.	z
Check for excessive vibration		z
Inspect Impeller for cracks or damage					z
Inspect for loose parts.		z

IMPELLER REMOVAL

1.Wait for engine to cool and disconnect spark plug.

2.Remove housing front cover, by removing (11) bolts and nuts, items #13 & #14, around outside of front cover.

3.Remove impeller bolt (item #35), lock washer (item #7) and washer (item #34).

4.DO NOT pry on impeller. Pull on center hub area only of impeller. If impeller slides off freely, proceed to (step 6).

5.If the impeller does not loosen, obtain a 3/4-16x1” (25.4mm) or longer bolt. Thread bolt by hand into nut until bolt rests against the shaft. Tighten the bolt slowly, which will pull the impeller away from the shaft, remove impeller from shaft. Using a penetrating oil can help loosen a stuck impeller.

6.Reinstall new impeller in reverse order of removal.

7.Tighten impeller bolt. Torque impeller bolt (see parts list on page 14 for proper impeller bolt torque specifications).

TIRE AIR PRESSURE

Check at regular intervals and maintain.

Front Tires - 24 Psi (165 kPa).

Rear Tires - 20 Psi (137 kPa).

STORAGE

Never store engine indoors or in enclosed poorly ventilated areas with fuel in tank, where fuel fumes may reach an open flame, spark or pilot light, as on a furnace, water heater, clothes dryer or other gas appliance.

If engine is to be unused for 30 days or more, prepare as follows:

Remove all gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and causing possible malfunction of engine. Drain fuel outdoors, into an approved container, away from open flame. Be sure engine is cool. Do not smoke. Run engine until fuel tank is empty and engine runs out of gasoline.

Fuel stabilizer (such as Sta-Bil TM) is an acceptable alternative for minimizing the formation of gum deposits during storage. Add stabilizer to gasoline in storage container or fuel tank. Follow stabilizer manufacturer’s instructions to determine proper mix ratio. Run engine at least 10 minutes after adding stabilizer to allow it to reach carburetor.

Part No 440187 10 Form No F091907C