FORCE BLOWER Owner’s Manual
ASSEMBLY
1.Follow the steps in figures A then securely tighten all hardware shown. 2.Connect spark plug wire.
Figure A
The hardware for attaching the upper handle to the lower is in the parts bag. Install upper handle (item 49), to preassembled lower handle (item 28) by sliding the upper over and down the outside of the lower handle. Using bolt (item #36), washers (item #10) & lock nut (item #11) to install upper handle to lower handle.
Finish installing the other side of the upper handle assembly using screw and lock nut provided.
Two ½” open ended wrenches
OPERATION
Like all mechanical tools, reasonable care must be used when operating machine.
Inspect machine work area and machine before operating. Make sure that all operators of this equipment are trained in general machine use and safety.
PUT OIL IN ENGINE BEFORE STARTING
STARTING
ENGINE: See engine manufacturer’s instructions for type and amount of oil and gasoline used. Engine must be level when checking and filling oil and gasoline.
FUEL VALVE: Move fuel valve to "ON" position (when provided on engine).
STOP SWITCH: Located on the engine. "ON" position.
CHOKE: Operated with choke lever on side of engine.
THROTTLE: Controlled by throttle lever on the engine. Pull starting rope to start engine.
ENGINE SPEED: Under normal conditions, operate at minimum throttle to accomplish your current cleaning task.
IF YOUR UNIT FAILS TO START: See Troubleshooting on page 12.
Part No 440187 | 8 | Form No F091907C |
