Billy Goat QB1004, QB884H, QB1304H, QB994S, QB654, QB1304HBW, QB554HC Troubleshooting, 112 dB

20	TROUBLESHOOTING		Before Requesting Service Review These Suggestions
	Problem	Possible Cause		Solution
Poor air performance		Air intake or exhaust clogged.		Clear clog.
Abnormal vibration.		Loose or out of balance impeller or loose engine.		Check impeller and replace if required. Check Engine.
Engine will not start.		Stop switch off. Throttle in off position. Engine not in full choke		Check stop switches, throttle, choke position and gasoline. Connect
		position. Out of gasoline. Bad or old gasoline. Spark Plug wire		spark plug wire. Clean or replace air cleaner. Or contact a qualified
		disconnected. Dirty air cleaner.		service person.
Engine is locked, will not		Engine problem.		Contact an engine servicing dealer for engine problems.
pull over.
Control Lever will not lock		Nut to secure lever is overtightened.		Loosen nut to allow play in control lever.
in middle position

Engine Service and Warranty

22.1Contact your nearest engine manufacturer's authorized

servicing dealer.

21 Serial Plate		Record your machine model, serial number and
		date-of-purchase and where purchased
			1803 S. Jefferson
			P.O. Box 308
			Lee's Summit,
			MO	64063 / USA
		R	Tel (816) 524-9666
			Fax (816) 524-6983
	Model			Serial No.
112 dB
	Unit(Weight)			Engine Power
	lbs.	kg		kW	rpm
					min-1
Purchase	Purchased
Date	from

Part No. 430316

WARRANTY PROCEDURE

22Please fill in the WARRANTY CARD and send the upper part to Billy Goat. The WARRANTY terms are stated on the lower part which remains with the user. Whenever a Billy Goat Machine is faulty due to a defect in material and / or workmanship, the owner should make a warranty claim as follows:

The Machine should be taken to the dealer from whom it was purchased or to an authorized Billy Goat dealer.

The owner should present the remaining half of the Warranty

Registration Card, or, if this is not available, the invoice or receipt.

The Warranty Claim will be filled in by the authorized Billy Goat Dealer, who will send it with the faulty part to Billy Goat headquarters.

The Quality / Service department at Billy Goat headquarters will study the claim and parts and will notify their conclusions.

The decision by the Quality / Service department at Billy Goat headquarters to approve or reject a Warranty claim is final and binding.

Note: To process a Warranty Claim, it is necessary to quote the Model & Serial number that are printed on the Billy Goat Serial Plate.

	BILLY GOAT INDUSTRIES INC.
	P.O. BOX 308 / LEE'S SUMMIT, MO. 64063-0308 / USA
	PHONE: 816-524-9666 FAX: 816-524-6983	www.billygoat.com
Page 12 of 12	Form No. F012203A