Billy Goat QB1601,QB1601SP owner manual Troubleshooting, Warranty Procedure

20	TROUBLESHOOTING	Before Requesting Service Review These Suggestions
	Problem	Possible Cause	Solution
Poor air performance		Air intake or exhaust clogged.	Clear clog.
Machine is difficult to maneuver.		Low tire air pressure.	Inflate front and rear tires to correct pressure.
			(See tire pressures on page 14.)
Abnormal vibration		Loose or out of balance impeller or loose	Check impeller and replace if required. Check
		engine.	Engine.
Engine will not start		Stop switches off. Choke lever not in on	Check switches, choke, gasoline and oil. Check
		position. Out of gasoline. Bad or old gasoline.	for spark with an approved tester. Clean or
		Spark Plug wire disconnected. Dirty air	replace air cleaner. Contact qualified service
		cleaner.	person.
Engine is locked, will not pull over.		Engine problem.	Contact your nearest engine manufacturers
			servicing dealer.

Self Propelled Units Only
No self-propelling	Transmission not in gear. Operator's bail not	Check transmission gear selection. Check clutch
	engaging belt or out of adjustment. Worn out or	cable adjustment, belt and chain (See page 14).
	broken chain. Broken or mispositioned belt.
Self propelled drive will not release	Sticking belt idler arm. Belt fingers bent or	Check idler. Idler arm mounting screw may be
	broken.	too tight or too loose. Check belt guide.
		Replace if broken.
Noisy or broken chain	No chain lubrication. Chain out of alignment or	See Chain Adjustments on page 14.
	over tensioned.

22.1	Engine Service and Warranty	22	WARRANTY PROCEDURE
	Contact your nearest engine manufacturer's		Should a Billy Goat Machine fail due to a defect in material and / or workmanship,
			the owner should make a warranty claim as follows:
	authorized servicing dealer.

21	Serial Plate	Record your machine model, serial number
		and date-of-purchase and where purchased

	1803 S. Jefferson
	P.O. Box 308
	Lee's Summit,
	MO	64063 / USA
R	Tel (816) 524-9666
	Fax (816) 524-6983

ModelSerial No.

115 dB
	Unit(Weight)			Engine Power
		Unit	kg		kW	rpm
		lbs.

@

Purchase Purchased

Datefrom

-The Machine must be taken to the dealer from whom it was purchased or to an authorized Servicing Billy Goat Dealer.

-The owner must present the remaining half of the Warranty Registration Card, or, if this is not available, the invoice or receipt. -The Warranty Claim will be completed by the authorized Billy Goat Dealer and submitted to their respective Billy Goat Distributor for their territory. Attention: Service Manager. Any parts replaced under warranty must be tagged and retained for 90 days.

-The distributor service manager will sign off on the claim and submit it to Billy Goat for consideration.

-The Technical Service Department at Billy Goat will study the claim and may request parts to be returned for examination. Billy Goat will notify their conclusions to the distributor service manager from whom the claim was received.

-The decision by the Quality / Service department at Billy Goat to approve or reject a Warranty claim is final and binding.

Note: To process a Warranty Claim, it is necessary to quote the Model & Serial Number which are printed on the Billy Goat Serial Plate (See owner’s manual).

BILLY GOAT INDUSTRIES INC.

P.O. BOX 308, 1803 S JEFFERSON LEE'S SUMMIT, MO. 64082-2312 / USA PHONE: 816-524-9666 FAX: 816-524-6983 www.billygoat.com

Part No. 430149 Page 16 of 16 Form No. F121903A