Bionaire BSF16 manual Fan Head Assembly

FAN HEAD ASSEMBLY

Step 1. Attach the neck of the fan to the upper extension pole. To do this, align the extension pole clasps and screw holes up with the corresponding holes on the neck of the fan. Once you have the neck adjusted to the angle of the extension pole clasps, screw the clasps to the neck of the fan until secure.

Step 2. Using your screwdriver, remove the securing screw that is located inside the Bionaire® decorative cap on the grill ring. Once you have unscrewed the grill ring, put it aside until you are ready to re- attach the grills.

Step 3. Remove the two plastic ties that

are holding the rear grill and the fan blade together. Discard the two plastic ties and cardboard.

Step 4. Loosen and take off the rear grill mounting nut ( H ) that is attached to the motor housing by turning counter-clockwise.

Step 5. Place the rear grill on the front of the motor housing; making sure that the handle on the back of the grill is above the motor housing (doing this will align the holes on the grill over the two screws in the housing). Then tighten the rear grill mounting nut onto the rear grill by turning clockwise.

NOTE : To know that the rear grill is on correctly, there will be one grill clip located at the bottom of the grill.

Step 6. Place the fan blade onto the motor shaft ( J ) making sure to align the flat area on the motor shaft with the flat area in the center of the fan blade. Slide the fan blade to the back of the motor shaft until it stops and the motor shaft is protruding.

Step 7. Insert the washer and tighten the nut onto the motor shaft to secure the fan blade. Complete the fan blade assembly by turning the fan blade cap counter-clockwise into the matching grooves in the center of the fan blade.

Step 8. Place the front grill onto the back grill so that the 2 clips on the top of the front grill fit over the rear grill. Also ensure that the bottom clip that is attached to the rear grill, attaches and fits onto the front grill when assembling the fan head.

NOTE: When attaching the grill ring, make sure to have the Bionaire® decorative cap (where the two ends of the grill ring meet)

at the bottom, center of the grills.

3