Bissell 1622 Maintenance and care, Empty the 2-in-1 water tank/clean removable nozzle, Operation

Operation

Empty the 2-in-1 water tank/clean removable nozzle

1.Turn power switch OFF (O). Remove the 2-in-1 water tank from the base using the tank carry handle. Carry the tank like a bucket to a utility sink or outside where you will dispose of the collection water. Remove the top of the tank by rotating the handle forward to unlatch lid and lifting lid off tank.

2.Empty collection water from bottom of tank.

3.After each use, remove and rinse the lint screen located on the tank lid.

4.If nozzle needs to be rinsed, remove by grasping handle at top and pulling forward. Clean removable nozzle by rinsing under running water.

5.When finished replace nozzle by slightly raising front of machine to line up slots on the base of the machine with the hooks on nozzle. Attach at base first and then click nozzle into place.

NOTE: If nozzle is not attached properly, loss of suction will occur.

6.To continue carpet cleaning refer back to page 7, beginning with “Fill the 2-in-1 water tank”.

If cleaning is complete, refer to the “Maintenance and care” section on below.

Maintenance and care

Machine care

For best results, a few simple steps can assure your machine is well maintained after your cleaning is complete.

1.Turn power switch OFF (O). Unplug the machine and wrap the power cord.

2.After emptying the 2-in-1 water tank, rinse it out at a faucet with running hand hot tap water, taking care to clean underneath and around the heavy duty bladder. Clean out red lint screen. Removable nozzle may be rinsed if necessary.

3.Replace the 2-in-1 water tank on the machine.

4.Any loose hair or debris can be pulled from the brush roll if desired and thrown away.

5.Wipe the machine’s exterior with a soft cloth.

6.After carpet is dry, vacuum again to remove hair and fuzz.

1.2.

Lint Screen

3.4.

5.

8 w w w . b i s s e l l . c o m