How To Deep Clean Carpet
Getting Ready
1. Remove dry filter bag from ball cage.
Remove concentrate measuring cup from filling cavity on
2. side of tank unit.
Pour two gallons of hot tap water (temperature should
3. not exceed 120° F/48° C) into filling cavity until level reaches bottom of three vertical lines in tank unit.
Shake bottle of BISSELL Carpet Care. Fill measuring lid to
4. fill line (10 ounces). Empty measuring lid into filling cavity and replace measuring lid.
5. Plug power cord into approved grounded outlet.
|
| |
| ||
1. | ||
switch, hold floor nozzle 4” - 6” above soiled carpet, and | ||
| pull trigger to spray cleaning solution. | |
| ||
| Wait | |
2. | ||
brush. |
| Deep Cleaning | |
| Turn on pump/spray and vacuum/suction switches. Place | |
1. | ||
floor nozzle directly on carpet at arm’s length. Pull trigger | ||
| to spray cleaning solution while pulling wand toward you. | |
| ||
| Repeat, keeping floor nozzle firmly against carpet | |
2. | ||
surface. Continue until no more dirt can be removed. | ||
| Do not overwet. | |
| ||
| Release spray trigger. Vacuum area until no more | |
3. | ||
cleaning solution can be removed. | ||
| Continue to clean entire carpet, working in 3’ x 4’ sections. | |
4. | ||
| If the machine loses suction, stops spraying and/or motor | |
5. | ||
noise rises in pitch, empty the tank [see WHEN YOU’RE | ||
| DONE, page 9]. Failure to empty tank will damage unit. | |
| ||
6. | If floor nozzle stops spraying, turn off pump immediately | |
and check cleaning solution level. Never run pump dry. |
8
Measuring
Cup
Remove Measuring Cup
From Filling Cavity
Filling Cavity
Tip:
Use only BIS- SELL Carpet Care in this appliance. Use of cleaning for- mulas which contain lemon or pine oil may damage this appliance and void warranty.
Vacuum/suction switch
Tip:
Deep cleaning stairs and high
Pump/spray switch traffic areas on a regular basis can prolong carpet life.
