Bissell 1698 How to use TurboBrush attachment, The Flow Indicator, ReadyTools Switch, Assembly

The Flow Indicator

This is located on the machine base. It spins when the trigger is pressed to indicate that the machine is applying cleaning solution to the floor. It will stop spinning to indicate that the SmartMix® Bottle or bladder needs to be refilled, or when

the trigger is released.

ReadyTools™ Switch

This provides above floor cleaning with the flip of a switch. Just choose the cleaning tool, attach to the flex hose and

POWERSTEAMER® PROHEAT™ PLUS is ready to clean upholstery and more.*

*Set the switch to Floor Cleaning when cleaning carpets or bare floors or set it

to Tools/PreTreat when using the flex hose attachments or for pre-treating floors.

*SmartTemp™ heats the cleaning solution for carpet and bare floor application only. It does not heat solution sprayed through the accessory tools.

Flow Indicator

ReadyTools™ Switch

TOOLS

PREHEAT

FLOOR

CLEANING

Tip:

A special red float device in the tank will cause the cleaner to stop removing solution from the carpet and the motor sound will rise in pitch to let you know the dirty water tank is full.

How to use TurboBrush™ attachment

Assembly

Unplug before attaching the TurboBrush™. Attach TurboBrush™ to the flex hose by pressing tool onto the grip/trigger until button snaps into hole.

Make certain tool is securely in place.

Use

1.Move the TurboBrush™ switch to the “BRUSH” position. This activates the brush.

When You’re Done

1.	Disconnect the TurboBrush™ from
	the vacuum flex hose by pushing
	down on the button lock and
	pulling straight off.
2.	Once removed from the flex hose, the
	TurboBrush™ can be cleaned:
	1. Move the switch to the

2.Place the tool directly on the soiled surface. Apply downward pressure on the tool and pull towards you while pulling trigger to spray cleaning solution.

3.Release the spray trigger and move the switch to the “SUCTION” position. Vacuum the area until no more cleaning solution can be removed.

SH BRU

SUCTION

	“SUCTION” position.
2.	Rinse under running water.
3.	Check spray nozzle for dirt.
	If necessary, clean with soft
	bristle brush.
4.	Replace TurboBrush™ in its
	special storage location on the
	handle front.

4.Repeat steps 1-3 until no more dirt can be removed.

Caution: Do not overwet.

9