Operations (continued)
Cleaning spills from hard surfaces 1. Turn power switch “I” (ON).
2. Press front of Spot Lifter 2X firmly against hard
surface to suction up spill.
2.
3.Press spray trigger to spray cleaning solution.
4. Press front of Spot Lifter 2X firmly against hard3. surface to suction cleaning solution, as in step
2 above.
NOTE: If the Spot Lifter 2X stops spraying, turn power switch “O” (OFF) and check cleaning solution level. Refill if needed. Never run dry.
Maintenance and care
Machine care
1.Turn power switch “O” (OFF).
2.Carry the Spot Lifter 2X to the sink or drain.
To empty the collection tank 1.
2.Remove the tank plug by turning approximately 1/4 turn counterclockwise and lifting out. Empty tank.
3.Thoroughly rinse the collection/dirty tank with clean water. Be sure to rinse nozzle area.
4.Replace tank plug and turn approximately 1/4 turn clockwise, until snug.
5.To replace the tank, pivot bottom of tank back into "hinge" and tilt up to handle. Press the tank release button, and snap the tank into place. Test for a secure fit before using.
NOTE: Check the solution/clean tank. If a significant amount of formula and water remains, you may leave it in the solution/ clean tank for your next cleaning task.
88 w w w . b i s s e l l . c o m
2.
3.
Tip:
Check spray nozzle for accumulated dirt or debris. If necessary, clean with soft bristle brush.
10/26/06 3:37:35 PM
