Bissell 1719 warranty Ni-Cad, Screws, the municipal waste, w w w . b i s s e l l . c o m, Remedies

Models: 1719

1 12
Download 12 pages 12.61 Kb
Page 9
Image 9
the municipal waste.
Troubleshooting
Reduced Suction / No Suction Possible Cause
1. Collection/dirty tank is full
2. Collection/dirty tank drain plug is loose
3. Batteries weak/undercharged
4. Collection/dirty tank not properly installed
Discard remainder of product.
8.
7. Keep battery packs together – DO NOT separate individual batteries. For proper battery disposal instructions, please contact your local authorities for requirements and regulations on safe disposal or recycling facilities in your area.
Remove wire connectors from the battery pack.
6.
4. Use a screwdriver to score rating label on bottom of unit.
5. Separate housings and locate battery pack in bottom/center of unit.
Note: If the battery is leaking, do not touch it. Contact your local authorities for a safe disposal or recycling facility in your area.
Remove tanks (front and rear) and discard.
Important: Unplug charger.
1.
2.
3. Remove screws (6) holding product housings together.
Maintenance and care (continued)
Machine storage
1. Clean exterior surface of Spot Lifter 2X with a soft cloth dampened with water only. Do not use a strong detergent or other cleaners as this may damage the finish.
2. Store Spot Lifter 2X in a protected dry area, at room temperature (40° - 110°F).
Battery removal and disposal
Note: The battery must be removed from the Spot Lifter 2X before it is disposed of.

w w w . b i s s e l l . c o m

ug603-5419_1719E_1006.indd 9

Ni-CadWARNING:

This product contains a rechargeable nickel cadmium battery (sometimes referred to as a “Ni-Cad” battery) pack. The average life of a Ni-Cad battery is 5 to 7 years, depending on frequency of use. Proper removal and disposal of Ni-Cad batteries is required. Do not dispose of in

the municipal waste.

Ni-Cad

3.

Screws

Screws WARNING:

To reduce the risk of electric shock, turn power switch OFF and disconnect charger from electrical outlet before performing maintenance or troubleshooting.

Remedies

1.Empty collection/dirty tank

2.Check plug for snug fit

3.Recharge according to instructions

4.Snap tank into place

9

10/26/06 3:37:36 PM

Page 9
Image 9
Bissell 1719 warranty Ni-Cad, Screws, the municipal waste, Empty collection/dirty tank 2. Check plug for snug fit, Remedies