Bissell 18Z6 Operation, Power switch/brush switch, Handle position, On the front of the handle

Assembly

Attach vacuum hose and tools continued

3.Snap the telescoping extension wand, crevice tool, and combination tool into storage clips as shown.

4.The Pet TurboBrush snaps on to the holder

3.

Combination Tool

on the front of the handle. Crevice Tool

Place the Pet TurboBrush in the holder by hooking the bottom onto the tab and pushing the top of the TurboBrush into place.

Telescoping Wand

Operation

Power switch/brush switch

The power switch is located just below the handle on the front of the detachable canister. Push the rocker switch “ON” (I) to vacuum, and “OFF” (O) when cleaning is complete.

The brush switch is located just below the handle on the front of the detachable canister next to the power switch. This switch turns the rotating brush on and off. The brush switch should be in the “ON” (I) position for normal carpet cleaning. You may want to turn the brush switch “OFF” (O) for bare floor cleaning or other delicate surfaces.

Note: Your BISSELL Lift-Off MultiCyclonic Pet vacuum is equipped with a special internal switch that turns the rotating brush off whenever the unit is in the Upright position.

Handle position

1.Upright- For storage and above floor clean- ing with special tools.

2.Normal Cleaning- Press handle release pedal once. Use for most household floor cleaning tasks.

Pet TurboBrushTM

caution:

Before using your vacuum, make sure that both filters (Pre-Motor and Post-Motor) are in place. Do not operate your vacuum without these filters.

Tip:

Your vacuum features a Quick-Release Cord Wrap. To remove the Power Cord quickly and easily, rotate the Upper Cord Wrap towards floor, and slip Power Cord from Upper and Cord Wraps..

1.

Power

2. Brush

16 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5