Check Rotating Floor Brush and Drive Belt Continued
5.Clean strings, hair and other debris from Rotating Floor Brush, paying particular attention to brush ends.
6.Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.
7.Check Drive Belt carefully for wear, cuts or stressed areas. Replace if worn.
8.Check Air Passageway for obstructions. Remove debris from this area.
Motor
Pulley
Air Passageway
Replace Drive Belt
Use only BISSELL Style 7 Replacement Belts (#32074) in your
BISSELL PowerForce.
1.
2. With Rotating Floor Brush removed from vacuum cleaner (Steps
3. | Place new Drive Belt over Motor Pulley and stretch other end |
|
| over Rotating Floor Brush in the space between the bristles. |
|
4. | Place ends of Rotating Floor Brush down into slots on sides |
|
| as shown. | Press here |
|
|
5.Turn Rotating Floor Brush by hand several times in direction of Motor Pulley. If properly installed, Drive Belt will center itself.
6. Reposition Brush Cover and four screws. Tighten screws securely. Make sure end of Brush Cover is snapped into place.
Replace Light Bulb
(Select Models)
Use only BISSELL Replacement Bulbs in your BISSELL PowerForce.
1.
2.Using a Phillips head screwdriver, remove the two screws as shown and lift off the lens.
3.Determine the light bulb type of your vacuum:
Standard Bulb
Large Bulb
4.Standard Bulb – remove the bulb from the socket by grasping bulb and pulling straight out. Install the new bulb by pushing it gently into the socket until the bulb snaps into place
Large Bulb – remove the bulb from the socket by pushing in gently and turning it towards brush. Install the new bulb by pushing it gently into the socket and turning away from the brush.
5. Reposition lens and secure with the two screws.
Small Bulb
Brush
Cover
Large Bulb
9
