Bissell 3593 warranty Check Rotating Floor Brush and Drive Belt

Maintaining Optional TurboBrush

Select Models Only

The TurboBrush should be checked regularly for clogs or debris wrapping around the brush roll.

Reposition lens and secure with the two screws.

3. Remove the bulb from the socket by pushing in gently and turning it counterclockwise. Install the new bulb by pushing it gently into the socket and turning clockwise.

4.

Replace Lightbulb

4. Place ends of Rotating Floor Brush down into slots on sides as shown.

5. Turn Rotating Floor Brush by hand several times in the direction of Motor Pulley. If properly installed, Drive Belt will center itself on Rotating Brush crown.

7. Check Drive Belt carefully for wear, cuts or stressed areas.

8. Check Air Passageway for obstructions. Remove debris from this area.

Replace Drive Belt

Check Rotating Floor Brush and Drive Belt Continued

4. Grasp Rotating Floor Brush at both ends and lift.
5.	Clean strings, hair and other debris from Rotating Floor
	Brush, paying particular attention to brush ends.	Motor Pulley

6.Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.

1.	Unplug cleaner from electrical outlet.	Air Passageway
2.	With Rotating Floor Brush removed from vacuum cleaner
	(Steps 1-4 of check Rotating Floor Brush and Drive Belt),

grasp old Drive Belt and remove from Motor Pulley. Discard old Drive Belt.

3.Place new Drive Belt over Motor Pulley and stretch other end over Rotating Floor Brush in the space between the bristles.

6. Reposition Brush Cover and screw or snap back into place. Check to be sure all screws or latches are secure.

1.Unplug cleaner from electrical outlet.

2.Using a screwdriver, remove the two screws as shown and lift off the lens.

1.Unplug vacuum from electrical outlet.

2. If a clog is present or debris is visible, unscrew the two screws on the back of the TurboBrush to remove the faceplate and clear any obstructions.

3. To clean debris from the brush roll, remove the screw located by the brush roll with a Phillips head screwdriver. Lift the belt cover. Remove the brush roll from the drive belt and clean debris.

12