Maintenance and care
Replace drive belt
1. | Unplug the vacuum from electrical |
|
| outlet. |
|
2. | With rotating floor brush removed from | 2 |
| ||
| vacuum cleaner (refer to page 10, steps | Motor |
| Pulley | |
| drive belt), grasp old drive belt and |
|
remove from motor pulley. Discard the old drive belt.
3.Place new drive belt over motor pulley and loop other end over rotating floor brush in the space between the bristles.
NOTE: It is important that you use only genuine BISSELL replacement belts. Generic belts may not meet the exact specifications required to keep your vacuum operating at its peak performance. The use of unbranded belts could lead to early failure of the vacuum and could void your warranty.
4.Pull the rotating floor brush firmly into position, stretching the drive belt, and place ends of rotating floor brush down into the slots on sides as shown. Alignment of brush ends in slots may be necessary to fully insert the brush.
5.Turn rotating floor brush by hand sev- eral times in the direction of motor pul- ley. If properly installed, drive belt will center itself on rotating brush crown.
6.Replace brush cover and all five screws.
3
4
11
w w w . b i s s e l l . c o m
