Bissell 4104 warranty Operations, Attach vacuum hose and tools, Power switch, Pet Hair Lifter

Assembly	1.
	3.

Attach vacuum hose and tools

1.Attach the Twist ‘n Snap™ Hose by lining up the tabs on the base with the corresponding notches on the back of the vacuum as shown.

2.Turn the Twist ‘n Snap Hose to the right to lock the hose into place.

3.Grasping the Quick Reach Handle, slide the end of the Hose Wand onto the Hose Wand Base. Snap the Hose into the Hose Clip.

NOTE: The vacuum will not operate effectively unless the hose wand is firmly attached.

4.Slide the extension wand and crevice tool into the storage clip on back of vacuum.

Twist 'n
Snap Hose	7.
8.

5.Slide the dusting brush/upholstery tool into the storage clip on back of vacuum.

6.Attach the Pet Contour Tool to the back of the vacuum by inserting tool into storage clip.

7.Store Pet TurboBrush on the front of the handle by lining up the TurboBrush base with the base of the holder then push back to snap into place.

8.Flip the pet hair lifter down until it clicks into place on the front of the foot.

NOTE: Flip the Pet Hair Lifter down for carpeted surfaces and up for non-carpeted surfaces (see page 7 for more information).

Operations

Power switch

The Power Switch is located on the left side of the vacuum. Push the rocker switch “ON” (I) to vacuum, and “OFF” (O) when cleaning is complete.

6 w w w . b i s s e l l . c o m

Pet Hair Lifter

CAUTION:

Before using your vacuum, make sure that the dirt container is in the locked position and that all filters (pre-motor and HEPA post- motor) are in place. Do not operate your vacuum without these filters.

NOTICE:

For above floor cleaning, the floor brush will continue to rotate but is raised above floor. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.

CAUTION:

To avoid personal injury and to prevent the cleaner from falling when cleaning stairs, always place it at the bottom of the stairs.

8 0 0 . 2 3 7 . 7 6 9 1