Assembly
Your deep cleaner assembles quickly and easily. The only tool you will need for assembly is a Phillips head screwdriver.
1.Locate the screw pack, which is taped to the upper handle.
2.Slide the upper body onto the lower body, taking care not to leave a gap between the upper and lower body.
3.Firmly holding the upper body, screw the
2 screws into the holes marked with arrows. Tip: If you are having difficulty tightening the screws, remove,
4.After tightening the screws, ensure proper fit between the upper and lower body by trying to separate the two. If assembled properly, there should be no gap. If a gap appears between the two (see picture at right), continue to tighten the screws until no gap is present.
5.Slide upper handle into upper body by aligning the pin and sliding into place.
NOTE: Be sure to secure upper handle before lifting. Rotate handle lock clockwise to secure.
6.Place solution tank on back of unit.
7.Wrap power cord.
Assembly is now complete.
2.3.
4.
INCORRECT CORRECT
5.6.
pin
Operations
Before you clean
1.Move furniture to another area if cleaning an entire room. (Optional)
2.Vacuum carpet thoroughly.
3.Plan your cleaning route to leave an exit path. It is best to begin cleaning in the corner farthest from your exit.
4.
4a. Generously spray BISSELL Tough Stain Pretreat evenly over soiled area.
Caution: DO NOT OVERWET CARPET 4b. Wait
Fill the tank
1.Remove the solution tank by lifting it straight up, then away from the lower body.
2.Unscrew the black cap at the bottom
of the solution tank.
w w w. b i s s e l l . c o m
Warning:
To reduce the risk of fire, use only BISSELL advanced deep cleaning formula for full size machines
in your deep cleaner. Use of cleaning formulas that contain lemon or pine oil may damage this appliance and void the warranty. Chemical spot cleaners or
1.2.
5
8 0 0 . 2 3 7 . 7 6 9 1
