Operations
Bag change indicator
The bag change indicator is located between the power button and the automatic cord rewind button. If the bag change indicator turns orange while you are vacuuming, the dust bag needs to be replaced. The dust bag may appear to be full or only partially full depending upon the type of debris picked up. Fine particles can block the airflow in the dust bag and reduce suction before the dust bag is full. If the bag change indicator remains orange, even after changing the dust bag, turn the vacuum off and check for a clog in the hose or tools.
Dust bag replacement
1.Unplug the vacuum from electrical outlet.
2.Disconnect hose
3.Open the dust bag compartment by lifting up on the latch on the door on the front of the vacuum.
4.Lift out the dust bag holder and dust bag.
5.Release the dust bag from the holder by pressing the dust bag holder clip and pulling the dust bag out of the holder. Discard the used dust bag.
6.Slide the new dust bag into the holder by inserting the dust bag into the tabs located at the bottom of the holder. Then press the dust bag holder clip, insert the dust bag and release the dust bag holder clip to hold the dust bag in place.
7.Place holder and new dust bag back into the dust bag compartment, making sure the entire bag is tucked in below the seal gasket.
8.Close dust bag compartment door and press down gently until it locks into place.
NOTE: The dust bag compartment door will not close without the dust bag in place.
9.Reconnect hose.
3.
4.
5
WARNING: To
reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
w w w . b i s s e l l . c a
1 - 8 0 0 - 2 6 3 - 2 5 3 5 | 9 |
