Troubleshooting, Thank you for selecting a BISSELL product

Troubleshooting

Possible causes

1.Vacuum cleaner is not plugged in

2.Power button is not pressed down

WARNING:

To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting.

Remedies

1.Check electrical plug

2.Press power button down

Possible causes		Remedies
1.	Tools, hose and/or extension wands are blocked	1.	Remove each part and check for blockages
2.	Filters are dirty	2.	Check and clean or replace all filters
3.	Dirt cup is full	3.	Empty dirt cup
4.	Hose connector not securely attached to suction inlet	4.	Make sure hose connector is locked into
			suction inlet
5.	Crack or hole in hose	5.	Check hose and replace if needed
6.	Air flow regulator is set to open or	6.	Change to closed or maximum setting
	minimum setting
7.	Clog in the dirt cup	7.	Clear clog from dirt cup following
			instructions on page 12
Visible dust escaping from vacuum
Possible causes		Remedies
1.	Dirt cup is full	1.	Empty dirt cup
2.	Filters missing or installed incorrectly	2.	Check all filters for correct installation
3.	Filters are dirty	3.	Check and clean or replace all filters
4.	Hose is blocked	4.	Remove hose and check for blockages
5.	Hose connector not securely attached to suction inlet	5.	Make sure hose connector is locked into
			suction inlet
6.	Crack or hole in hose	6.	Check hose and replace if needed
7.	Dirt cup is open	7.	Follow Emptying the dirt cup instructions step(s) (1-5)
			on page 8

Other maintenance or service not included in the manual should be

performed by an authorized service representative.

w w w. b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1