16 www.bissell.com 800.237.7691
WARNING:
To reduce the risk of fire, electric
shock or injury, unplug from the
outlet before servicing.
Troubleshooting
Heat indicator light does not illuminate
Possible Causes Remedies
1. The heater switch is not turned on. 1. Turn on the heater switch located on
side of unit.
2. The machine po wer switch is not 2. Both switches must be on
turned on. to activate the heat indicator light.
Reduced spray OR no spray
Possible cause Remedies
1. Bladder may be empty. 1. Turn power switch off; Refill bladder
with clean hot tap water and formula.
2. 2-in-1 tank may not be seated properly. 2. Turn power switch off; remove tank
and reseat tanks.
3. Pump may have lost prime. 3. Turn power switch off; after 1 minute
turn o n and depress spray release trigger.
4. The pump belt may be broken. 4. Turn power switch off and unplug
from the outlet. To check if a pump belt has
broken, you will need a flat head
screwdriver.
A. Insert the blade end into the slot of the
belt access door to release. Examine the
belt for breakage. You should be able to see
the pump belt looped around the motor shaft.
If it is broken or missing, please refer to
Replacement Parts on page 18.
A replacement belt may be ordered at
www.bissell.com or by calling BISSELL
Consumer Services at 800-237-7691.
Complete installation instructions
will accompany the replacement belt.
B. When replacing belt access door be sure to
line up slots of belt access door with slots in
machine, slide door into place and snap shut.
Slots
A.
B.
Pump Belt
ug120-4078_25A3_908.indd 16 10/14/08 1:21:09 PM