Bissell 6583 Maintenance and care, Emptying dirt container, Empty dirt into garbage container

Maintenance and care

To maintain maximum cleaning performance from your BISSELL PowerForce Bagless, perform these simple maintenance steps.

1.Empty the dirt container when the dirt reaches the “Full” line on the side.

2.Check the inner and outer circular filters, and the pre-motor filter at least once a month and clean or replace as needed.

3.Clean or replace the post-motor filter every three to six months.

Note: More frequent filter cleaning or replacing may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the following pages to perform these simple maintenance steps.

Emptying dirt container

The dirt container needs to be emptied when the dirt reaches the “Full” line on the side of the container.

1.Unplug cleaner from electrical outlet.

2.Slide the Lock ‘n Seal lever to the "Unlock" position.

3.Grasp handle and pull the dirt container straight out to remove from vacuum.

4.Empty dirt into garbage container.

5.Put the dirt container back in the vacuum and slide the lever to the "Lock" position.

Note: The dirt container may be washed in warm water with a mild detergent. Remove the filter cup from the bottom before washing. Reassemble and make sure it is completely dry before using again.

WAR NING:

To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.

Tip:

For maximum cleaning performance, check and clean, or replace all filters as suggested.

Unlock		Full Line
	Lock Position
Position

8 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5