Maintenance and care
Replace lightbulb
1.Unplug the vacuum from electrical outlet.
2.Using a flat bladed screwdriver, pry the tab on the left and right side out and pull out to remove the lens.
3.Remove the bulb from the socket by grasping the bulb and pulling gently. Install the new bulb by pushing it gently into the socket until the bulb snaps into place.
4.Reposition the lens and snap it back into place.
2.
3.
4.
Maintaining Pet TurboBrush®
The Pet TurboBrush should be checked regularly for clogs or debris wrapping around the brush.
1.Unplug the vacuum from electrical outlet.
2.If a clog is present or debris is visible, unscrew the two screws on the back of the TurboBrush to remove the faceplate and clear any obstructions.
3.To clean debris from the brush, remove the brush from the drive belt and clean debris.
4.Reposition the drive belt on the brush. Place ends of brush in slots on sides. Reposition faceplate and secure with two screws.
NOTE: This tool is designed to remove pet hair from upholstered or carpeted surfaces. It should not be used on pets.
8 0 0 . 2 3 7 . 7 6 9 1
