Bissell 6900 warranty Replacing the Drive Belt, Replacing The Light Bulb

Cleaning the DirtLifter® PowerBrush

The Brush can usually be cleaned without removal from the vacuum. If there is an excessive amount of hair and debris, however, it is best to remove the Brush.

		Pressing down on the Powerfoot Release button, detach
1.
		the Powerfoot from the Extension Wand.
		Lay the Powerfoot face forward on the floor.
2.
		Locate the locking screws (6) on the bottom of the
3.
		Powerfoot. Using a Phillips head screwdriver, remove the
		screws. Lift off the Brush Cover. Grasp the Brush firmly,
		and pull it out. The Brush has metal end caps featuring
		a square at the center. They can be removed for easier
		cleaning, but make sure they are properly reinserted
		before installing the Brush. Remove the Drive Belt from
		the roller, set aside.
		Clean debris from Brush. Lint, carpet pile, and hair can
4.
		be removed with a pair of scissors. If brush bristles are
		worn or missing, replace Brush.
		Slide Belt over Brush onto the belt track. Slide Belt over
5.
		the Motor Pulley. To reinstall Brush, slide square ends of
		Brush into grooves, beginning with the Belt side. The Drive
		Belt should have room to rotate within the belt channel.
		Make sure Drive Belt is looped over roller and not twisted.
		Inspect Belt action by rolling the Brush with the palm of
		your hand.
		Reattach Brush Cover to Powerfoot with (6) screws.
6.
	Replacing the Drive Belt
		Follow steps 1, 2 and 3 from the "Cleaning the
1.
		DirtLifter® PowerBrush" section.
		Remove old Belt from Brush.
2.
		Attach new Belt, aligning as indicated in step 5 and 6
3.
		from the "Cleaning the DirtLifter® PowerBrush" section.
		Replacing The Light Bulb
		To replace the Light Bulb in the Powerfoot, follow steps 1, 2
1.
		and 3 from "Cleaning the DirtLifter® PowerBrush" section.
		Remove old Bulb from Bulb Socket. Insert new Bulb.
2.
		Refer to step 5 an 6 from "Cleaning the DirtLifter®
3.
		PowerBrush" section.

WARNING:

Unplug from outlet when not in use and before servicing.

9

ug603-4424_6900_705 9 7/27/05 11:56:03 AM