cleaning with your spot cleaner
1. Plug the unit in and turn on by pressing button
under handle.
2. Hold the tool approximately 1” above the
soiled surface. When using the Deep Reach Tool
(select models), keep the tool in contact with the
carpet while spraying. Press the spray trigger to
apply the cleaning solution to the soiled area.
3. Using the brush on the tool, gently scrub the
area to be cleaned.
4. For thorough cleaning, spray additional
solution while the brush and suction are in
contact with the surface.
5. Apply downward pressure on the tool and pull
it toward you. The suction will remove the dirt
and cleaning solution. Continue until no more
dirt can be removed.
6. As a final step, use “drying strokes” (by not
pressing the spray trigger) to remove as much
liquid/moisture as possible. Repeat this step as
often as necessary.
cleaning with the Stain trapper tool (select models)
Your deep cleaner may have come with a
stain Trapper tool. This tool is great for keeping
messes out of the machine’s hose system.
1. Attach the stain Trapper tool to the end
of the hose.
2. slowly move the tool back and forth over the
stain. be careful not to move the tool back and
forth too quickly or soiled water will flow back
into the hose.
3. To empty the stain Trapper tool, rotate
the small tank on the bottom of the tool
to unlock it.
notE: be careful to keep the top of the tool
facing upward or soiled water will spill out of
the tank, and into the hose.
4. Dump dirty water into a sink or toilet and
rinse the tank out with clean water. Replace the
tank by lining up the locking teeth with their
mating slots (make sure the two teeth that are
closest together are pointed toward the brush).
Turn the tank to lock it into place.
5. Clean the front of the tool by removing the
plate over the suction path. Pull down on the
plate to remove. Run the tool and the plate
under clean water to rinse taking care to remove
all debris. Replace the front plate by sliding it
back into place.
Operatiswww.bissell.com 800.237.7691
WaRnInG
Keep spray away from face. Failure to do
so may result in personal injury.
ImpoRtant
Check the manufacturer’s tag before
cleaning upholstery. “W” or “WS” on the tag
means you can use your SpotClean. If tag
is coded with an “S” (with diagonal strike-
through), or says “Dry Clean Only,” do not
proceed. If manufacturer’s tag is missing or
not coded, check with your furniture dealer.
7
3 .
5.