Troubleshooting

WARNING:

To reduce the risk of fire, electric shock, or injury, unplug machine from outlet before servicing.

Reduced spray or no spray.

Possible Causes

1Bladder may be empty

2The lint screen may be clogged

3Tank-in-Tank may not be seated properly

4Pump may have lost prime

5The Pump Belt may be broken

Lift Here

Insert

Screwdriver

Blade Here

Remedies

1Turn power OFF, refill tank with hot tap water.

2Turn power OFF, clean out lint screen, follow step 2 on page 6.

3Turn power OFF; remove and reseat tank.

4Turn power OFF; after 1 minute, turn ON and depress Spray trigger.

5Turn power OFF and unplug machine from outlet. To check if a Pump Belt has broken, you will need a flathead screwdriver. Insert the blade

end into the lower slot of the Belt Access Door to release the latch.

If necessary, insert the blade end into the upper slot to release the upper latch. Examine for belt breakage. You should be able to see the Pump Belt looped around the motor shaft. If it is broken or missing, please refer to the part numbers and descriptions on page 11 before calling BISSELL Consumer Services. Complete installation instructions will accompany the replacement belt.

PowerSteamer is not picking up solution.

Possible Causes

Remedies

1Nozzle Window may not be properly attached

2Tank-in-Tank Lid is not properly installed

3Tank-in-Tank is not properly seated

4Tank-in-Tank has picked up the maximum amount of dirty water

1Make sure the two tabs on the back of the Floor Nozzle Window are inserted through the mating slots in the main housing. Reinstall if necessary.

2Reinstall lid; refer to page 6.

3Tank-in-Tank must be firmly seated to function. Remove and reseat Tank-in-Tank.

4Empty tank and refill; refer to page 6.

Thank you for selecting a BISSELL product.

If you should happen to need assistance during assembly or operation, call: 1-800-237-7691

Please do not return this

product to the store.

9

Page 9
Image 9
Bissell 1685, 8940 warranty Troubleshooting, Possible Causes, Remedies