Assembly, Before you begin cleaning

Assembly

1.Slide upper handle onto machine base

2.Screw 3 screws into the marked holes

3.Place upper hose rack onto back of upper handle, and secure with screw

4.Place lower hose rack onto back of upper handle by pushing in and sliding down until it snaps firmly into place

5.Wrap power cord and flex hose

6.Keep flex hose snugly in place by using the hose secure latch

7.Attach tool to hose grip (extra tool storage on back)

1.		2.		3.

a. Tough Stain Brush

1.Move furniture to another area if cleaning an entire room

2.Remove large dirt and debris from carpet (See User's Guide for more details)

3. Pre-treat spots & stains and heavy traffic areas (optional – see User's Guide)

4.Fill the clean water tank

4a. Unlatch the top by lifting up on tank latch

4b. Remove the top

4c. Fill the bladder with clean hot tap water

4d. Re-attach top by hooking the lip of the tank top into the groove of the tank bottom and secure the latch

5.Fill the formula tank with water and BISSELL 2X formula

5a. Remove formula tank and unscrew the cap and insert

5b. Fill with water to the WATER line

5c. Fill with BISSELL 2X formula to the FORMULA line

5d. Replace cap and insert and place back into formula tank holder

6.Set Custom Clean Dial (located on the upper handle)

7.Set ReadyTools Dial ("Floor Cleaning” for carpet cleaning or “TOOLS” for cleaning with the hose and tool)

8.Plug into outlet, and turn the power and heater (if desired) switch on

9.If using the heater, let the machine warm up for 1 minute before cleaning

4a.

4b.

4c.

4d.

5a.

5b.

Power

Heater

For complete user's guide, visit www.bissell.com