![](/images/new-backgrounds/1059572/5957271x1.webp)
DMOC205SS
VMOC205SS
7.Make sure the door is parallel with oven face lines (left and upper side lines) and door latch heads pass through latch holes correctly.
8.Insert the lower oven hinge into oven cavity bottom flange and then engaged the door hinge pin. Then secure the lower oven hinge firmly with tree (3) mounting screws.
Note: After any service to the door;
(A)Make sure that door sensing switch and secondary interlock switch are operating properly. (Refer to chapter "Test Procedures".).
(B)An approved microwave survey meter should be used to assure compliance with proper microwave radiation emission limitation standards.
DOOR ADJUSTMENT
The door can be adjusted by keeping screws of each hinge loose.
After adjustment, make sure of the following :
1.Door latch heads smoothly catch latch hook through latch holes and that latch head goes through center of latch hole.
2.Deviation of door alignment from horizontal line of cavity face plate is to be less than 1.0mm.
3.Door is positioned with its face pressed toward cavity face plate.
4.
Note: The door on a microwave oven is designed to act as an electronic seal preventing the leakage of microwave energy from oven cavity during cook
cycle. This function does not require that door be airtight, moisture
UPPER OVEN HINGE
DOOR ASSEMBLY
LATCH
HEADS
LOWER OVEN HINGE
Figure C-5. Door Replacement and adjustment
DOOR DISASSEMBLY
Remove door assembly, refer to "Door Replacement". Replacement of door components are as follows:
1.Place door assembly on a soft cloth with latches facing up.
Note: As the engaging part of choke cover and door panel are provided at several places, do not force any particular part.
2. Insert an putty knife (thickness of about 0.5mm) into the |
gap between the choke cover and corner portion of door |
2 LIFT UP
PUTTY KNIFE
1 BENT
CHOKE COVER
Door Bent
Panel
Upper
INSIDE Choke
cover
Lower
| panel as shown Figure |
3. | Lift up choke cover. |
4. | Now choke cover is free from door panel. |
FRONT
Figure C-6. Door Disassembly
34