Black & Decker BDBN1200 Maintenance, Rbrc Seal, Accessories, Clearing a Jammed Nail Figure

625779-00 BDBN1200Booklet 8/9/04 9:55 AM Page 9

There are two drive positions:

1.To drive the nail shallower, press the depth lock button and slide the depth adjustment bar to the forward position. Release the depth lock button.

2.To sink a nail deeper, press the depth lock button and slide the depth adjustment bar

to the full rear position. Release the depth lock button.

Clearing a Jammed Nail (Figure 4)

If a nail becomes jammed in the nosepiece, keep the tool pointed away from you and follow these instructions to clear:

1.Engage lock off.

2.Disconnect battery.

3.Release pusher from behind nails.

4.Pull up on latch then pull up to open front door.

5.Remove bent nail, using pliers if necessary.

6.If driver blade is in the down position, insert screwdriver or other rod into nosepiece and push driver blade back in position.

7.Remove rod and close front door.

8.Lift latch to engage wire and pull back to lock in place.

9.Reinsert nails into magazine (see Loading the Tool).

10.Push magazine closed until it locks in place.

4

Maintenance

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.

The RBRC™ Seal

The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel-cadmium battery (or battery pack) indicates that the

costs to recycle the battery (or battery pack) at the end of its useful life

have already been paid by Black & Decker. In some areas, it is illegal to place spent nickel-cadmium batteries in the trash or municipal solid waste stream and the RBRC program provides an environmentally conscious alternative.

RBRC in cooperation with Black & Decker and other battery users, has established programs in the United States and Canada to facilitate the collection of spent nickel- cadmium batteries. Help protect our environment and conserve natural resources by returning the spent nickel-cadmium battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery, or call 1-800-8-BATTERY.

Accessories

Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call:

1-800-544-6986.

WARNING: The use of any accessory not recommended for use with this tool could be hazardous.

9